seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Transport of automatic gearbox > < Gearbox, for vehicles with turbo diesel engine. Removing and installing

Leon Mk1

Selector lever locking solenoidN110 : removing and assembling
Selector lever locking solenoid -N110- : removing and assembling
t  Selector lever locking solenoid -N110-: Removing → Anchor
t  Selector lever locking solenoid -N110-: Fitting → Anchor
Removing
–  Remove selector mechanism trim → Chapter.
–  Remove the air conditioner operating unit → Rep. gr.87.
–  Remove the ash tray installed in the centre console → Rep. gr.68.
   
–  Unplug electrical connector at selector lever lock solenoid -N110-.
–  Press retaining hook -A- into selector mechanism -arrow- and hold in.
  Note
The shift unit must be renewed if the retaining hook -A- breaks off.
  A37-10399
–  Lower the bottom part of selector lever lock solenoid -N110- in direction of -arrow- so that ball head -1- disengages from operating lever on selector mechanism.
–  Detach selector lever lock solenoid -N110-.
Installing
Install in reverse order, observing following:
–  Turn ball head -1- into correct installation position.
–  Insert selector lever lock solenoid -N110- into selector mechanism at an angle from above.
–  Tilt bottom part of selector lever lock solenoid -N110- in opposite direction of -arrow-.
  A37-10400
–  Ball head -1- must engage fully in operating lever on selector mechanism.
–  Secure selector lever lock solenoid -N110- to retaining hook -A-.
–  Install the ash tray installed in the centre console → Rep. gr.68.
Tightening torque
  A37-10399
ComponentNm
Housing for ashtray (front) to mounting frame for centre console3

–  Install the air conditioner operating unit → Rep. gr.87.
–  Install gear selector mechanism cover → Chapter.
   

Transport of automatic gearbox > < Gearbox, for vehicles with turbo diesel engine. Removing and installing