seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Seal for the left hand side flanged shaft: replace > < Assembly overview: Flange shaft, seals and brackets on the gearbox

Leon Mk1

Left hand side flange shaft: Removing and installing
Left hand side flange shaft: Removing and installing
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Extractor -SAT 1100-, see equivalent → Anchor
  W00-2708
t  Torque wrench kit -SAT 8010-, see equivalent → Anchor
Removal:
  Note
t  Cleaning norms when working in the gearbox → Chapter.
t  General repair instructions. → Chapter
–  Remove drive shaft (left-side) → Running gear, front-wheel drive and four-wheel drive; Rep. gr.40.
–  Place used oil collection and extraction unit -SAT 1100- below gearbox.
  L00-10226
–  Unscrew the conical bolt of the left hand articulated shaft; for this purpose screw in the two bolts into the flange and lock the shaft with a lever -according to the figure-.
–  Remove flanged shaft together with compression spring.
Installation
Installation is carried out in reverse order. The following must be taken into account:
  Note
Renew countersunk bolt securing flange shaft.
–  Insert the flanged shaft pushing against the spring and fix with a new bolt. Tightening torque → Chapter
–  Install drive shaft (left-side) → Running gear, front-wheel drive and four-wheel drive; Rep. gr.40.
–  Gear oil level: checking and topping up → Chapter
  V34-2737

Seal for the left hand side flanged shaft: replace > < Assembly overview: Flange shaft, seals and brackets on the gearbox