SEAT Workshop Service and Repair Manuals

Gearbox mounting and gearbox support foot: Removing and installing Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Torque wrench kit -SAT 8010-, see equivalent → Anchor

t  Socket -U-30025E -, see equivalent → Anchor Removal:   Caution Risk of damaging the engine cover. When removing, the instructions given below should be followed in the order shown. –  Remove the engine cover and the air filter housing → Rep. gr.24. –  Remove battery → Rep. gr.27.

–  Remove battery tray -arrows-.

–  Fit the engine and gearbox support -U 30025E- on wing panel flanges and protect them against possible scratches. –  Partly take up weight of engine with spindle, but do not lift.   Note The gearbox support assembly does not have to be removed when removing the gearbox mounting.

–  Unscrew the bolts-2- for loosening the gearbox support assembly and remove the gearbox supports. –  Unscrew and remove the bolt -1- . –  Carefully lower the engine/gearbox assembly via the spindles. –  Remove the gearbox support -A-. Removing gearbox mounting:

–  Dismount all the necessary pieces to obtain access to the bolts -1-. –  Unscrew bolts -1-. –  Remove bevel box carrier -A-. Installation Installation is carried out in reverse order. The following must be taken into account: l  Tightening torques → Chapter

When the gearbox support -A- is removed: –  Fit the gearbox support -A-. –  Secure gearbox mounting -A-. –  Pull up the gearbox when using the spindle of the support bracket until gearbox support contacts support arm of gearbox mounting. –  Fir the screw and -2- screw-in.   Caution The threads in the gearbox support can be damaged if the bolts are not inserted straight. Before tightening the bolts -2-, the gearbox support and the support arm of the gearbox mounting must be positioned absolutely parallel to each other. If necessary, push the gearbox up at the rear with a trolley jack. –  Adjust assembly mountings → Rep. gr.10. –  Remove the support -U30025E - from the engine.