seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine cooling > < Removing and installing cylinder head

Leon Mk1

5-cyl. injection engine, (4-valve), Mechanics
Removing and installing parts of the lubrication system
Dismantling and assembling oil filter housing
 
N17-0163
  • Sealing cover, 15 Nm
    • ◆ If sealing ring is leaking nip open and replace.
  • 1.4 bar oil pressure switch (F1), 20 Nm
    • ◆ Identification: black
    • ◆ If sealing ring is leaking nip open and replace.
    • ◆ Checking
  • Oil filter housing
    • ◆ With non-return valve
          Opening pressure:
      0.05 bar pressure
  • O-ring
    • ◆ Renew
    • ◆ Oil before installing
 
N17-0163
  • Oil cooler
    • ◆ Ensure clearance to adjacent components
    • ◆ Coat contact surfaces outside the seal with AMV 188 100 02
    • ◆ See note
      => Page 17-1
    • ◆ Coolant hose connection diagram
  • Seal
    • ◆ Renew
    • ◆ Oil before installing
  • Oil cooler cover, 25 Nm
  • O-ring
    • ◆ Insert in oil cooler before installing oil cooler
    • ◆ Renew
    • ◆ Oil before installing
  • 23 Nm
 
N17-0163
  • Oil filter element
    • ◆ Observe change intervals
    • ◆ See note
      => Page 17-1
  • Oil filter lower part, 25 Nm
    • ◆ Drain before removing
    • ◆ With by-pass valve
          Opening pressure:
      2.5 bar pressure
  • Oil drain screw, 10 Nm

Engine cooling > < Removing and installing cylinder head