Leon Mk1
Heating unit: dismantling and assembling |
1 - | Heat exchanger |
q | Bleed coolant |
q | Renew: remove the dash panel and heating equipment |
q | After the dismount you should renew all the coolant |
2 - | Self-tapping screw |
3 - | Air distributor housing |
q | Do not continue to take apart |
4 - | Depressant for fresh air flap and air recirculation |
5 - | Self-tapping screw |
6 - | Fresh air blower with overheating fuse series resistor -N24- |
q | Removal and installation → Fig. |
7 - | Gasket |
q | Renew |
8 - | Gasket |
q | Renew |
9 - | Duct distributor, lower part |
q | Assembly → Fig. |
10 - | Plastic nut |
11 - | Fresh air blower -V2- |
q | Removal and installation → Chapter |
12 - | Self-tapping screw |
13 - | Screw |
14 - | Central flap lever |
q | Installation position → Fig. |
q | Adjusting actioning cable → Fig. |
15 - | Temperature flap lever |
q | Mounting and adjusting → Fig. |
16 - | Self-tapping screw |
17 - | Deicing intermediate piece |
18 - | Basic plate |
19 - | Heat exchanger gasket/bulkhead |
q | Note the fitting position → Fig. |
q | Renew |
|
|