Leon Mk1
Component extensions “2” |
1 - | Condensation drain |
q | Checking, removing and fitting → Chapter |
2 - | Expansion valve |
q | Removing and refitting the refrigerant tubes → Chapter |
q | Removing and installing → Chapter |
3 - | Coolant ventilator (01018-3433) -V7- |
q | The request to connect the fan is sent by the Climatronic control unit (01320) -J255- through the data bus system to the engine control unit. The engine control unit then activates the fans directly or through the Liquid coolant fan control unit C1781 (00831) -J293- → Engine, mechanics; Rep. Gr.19 |
q | The corresponding control unit activates, for example, the Coolant ventilator (01018-3433) -V7- (through the Coolant ventilator control unit C1781 (00831) -J293-) according to the power required (and depending on the engine fitted) → Vehicle diagnosis, testing and information system VAS 5051, → Current flow diagrams, Electrical fault finding and Fitting locations |
q | Depending on the vehicle options, different versions are fitted → Parts catalogue |
q | Check the activation of the Climatronic control unit (01320) -J255- → Vehicle diagnosis, testing and information system VAS 5051 |
4 - | High-pressure sender (00819) -G65- |
q | Operation, disassembling and assembling → Chapter |
q | The measurement value of the sender is viewed by the function “Read measurement block values” of the Climatronic control unit (01320) -J255- → Chapter and → Vehicle diagnosis, testing and information system VAS 5051 |
5 - | Service connection |
q | High-pressure end |
q | Used by specialised air conditioning workshops, to measure, empty and fill |
q | Hood with seal, always screw into place |
q | Depending on the version of the engine fitted, it may be necessary to remove certain components (for example the active carbon filter) to connect the charging station |
6 - | Service connection |
q | Low-pressure end |
q | Used by specialised air conditioning workshops, to measure, empty and fill |
q | Hood with seal, always screw into place |
q | Depending on the version of the engine fitted, it may be necessary to remove certain components (for example the active carbon filter) to connect the charging station |
7 - | Fresh air inlet cover |
q | Check the correct positioning, ensure that water does not enter into the air conditioning inlet |
8 - | Fresh air inlet grill |
q | Check the correct positioning, ensure that impurities (for example leaves) does not enter into the air conditioning inlet |
9 - | Temperature sender - fresh air intake duct (00787-3213) -G89- |
q | Removing and fitting, check the resistance value → Vehicle diagnosis, testing and information system VAS 5051 |