SEAT Workshop Service and Repair Manuals > Leon Mk1 > Heating and air conditioning | Heating and air conditioning | Air conditioner

Attaching compressor to the support

Installation is carried out in reverse order, noting the following:

–	Before fitting the compressor, check the correct positioning of the two sleeves -arrow- on the support or on the compressor.

–	Fit accordingly, a washer on the attachment bolts -arrows- (torque 25 Nm).

–	Check, after fastening the compressor, the layout of the coolant pipes. These should be fixed in supports prepared for this purpose (if available, depending upon the engine).

–	After attaching compressor, also check refrigerant pipes and corresponding holders for adequate clearance with respect to other components; pay special attention to adequate distance between belt, support and pulley.

SEAT Workshop Service and Repair Manuals