seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Components of the manual air conditioning (Climatic) > < Capacities
Exploded view of components
Exploded view of components
HD = High-pressure end (high density)
LP = Low-pressure side
   
1 - Compressor control valve, air conditioning -N280-
q   Check activation and operation → Anchor1)
2 - Compressor:
q   Detaching compressor from holder/re-attaching → Chapter and → Anchor1)
q   When installing the refrigerant pipes and the corresponding holder, make sure there is sufficient distance between the belt, holder and pulley.
q   Type of compressor differs depending on engine (attached to right or left of engine, 6-cyl. diesel or petrol engine) → Spare parts catalogue
q   Different types of compressor are fitted depending on country version (e.g. “Denso” type designation “6 SEU” for Europe and “7 SEU” for hot countries) → Spare parts catalogue
3 - Pulley/compressor drive unit to engine
q   Replace the pulley → Chapter
q   Removing and installing poly V-belt → Anchor1) and → Engine, mechanics; Rep. Gr.13
q   Ribbed belt allocation: → Spare parts catalogue
q   Checking/renewing compressor drive unit
  Note
t  A rubber element is fitted between pulley/drive unit and drive shaft of compressor to protect belt/drive gear unit in the event of compressor blockage or stiffness.
t  The rubber section interrupts power transmission to the compressor if the compressor is sticking.
t  A rubber element is fitted between the engine and compressor to protect the drive gear unit in the event of compressor blockage or stiffness.
t  These rubber elements absorb any vibration occurring during compressor operation (damper function in the case of torque fluctuations).
4 - Oil drain bolt
5 - Pressure relief valve
6 - Junction with valve
7 -  High-pressure sender -G65- → Anchor1)
q   Removing and installing → Chapter
q   Checking signal
8 - Condenser
9 - Cover cap
q   With seal
q   Always bolt on
10 - Service connection
q   High-pressure side.
q   For specialist air conditioner workshop for measuring, draining and filling
11 - Screw connection in refrigerant pipe
12 - Restrictor:
q   Fitted in screw connection -item → Item-
13 - Evaporator
14 - Service connection
q   Low-pressure side.
q   For specialist air conditioner workshops for measurement and drainage
15 - Cover cap
q   With seal
q   Always bolt on
16 - Collecting tank

   

Components of the manual air conditioning (Climatic) > < Capacities