Leon Mk1
Component extensions |
1 - | Temperature sender for the left hand side air vent -G150- |
q | Not fitted in vehicles with manual climate control |
q | Removing and fitting → Chapter |
2 - | Diagnosis connector |
q | Finish the air conditioning self-diagnosis → Vehicle diagnosis, testing and information system VAS 5051 |
3 - | Accelerator control |
q | The deactivation of the Climatronic control unit -J255- compressor Kick-Down (through the Compressor regulation valve, air conditioning -N280-) is performed at the request of the engine control unit (information is exchanged over the data bus). The measurement values block for the Climatronic control unit -J255- can be used to check the actual state → Vehicle diagnosis, testing and information system VAS 5051 |
4 - | Flexible condensation drainage tube |
q | Checking, removing and fitting → Chapter |
5 - | Left seat thermosensor -G59- and left heated seat -Z6-, driver's heated seat back -Z7- |
q | Thermal or heated seats are not fitted in every vehicle (optional equipment) |
q | Heated seats are controlled by the heated front seats control unit -J774- → Current flow diagrams, Electrical fault finding and Fitting locations |
q | The activation of the seat heating may be seen in the measurement values block of the Climatronic control unit -J255-, test → Vehicle diagnosis, testing and information system VAS 5051 |
q | Repairing the thermal seat → Bodywork, interior fitting work; Rep. Gr.74 |
6 - | Right seat thermosensor -G60- and right heated seat -Z8-,passenger's heated seat back -Z9- |
q | Thermal or heated seats are not fitted in every vehicle (optional equipment) |
q | Heated seats are controlled by the heated front seats control unit -J774- → Current flow diagrams, Electrical fault finding and Fitting locations |
q | The activation of the seat heating may be seen in the measurement values block of the Climatronic control unit -J255-, test → Vehicle diagnosis, testing and information system VAS 5051 |
q | Repairing the thermal seat → Bodywork, interior fitting work; Rep. Gr.74 |
7 - | De-icing vent |
q | Passenger side window |
q | Removing and fitting → Bodywork, interior fitting work; Rep. Gr.70 |
8 - | Left hand side dashboard vent |
q | Removing and fitting the dashboard air vent → Chapter and → Bodywork, interior fitting work; Rep. Gr.70 |
9 - | Instrument panel control unit with indication lamps -J285- |
q | With the Outside temperature indicator -G106- |
q | The outside temperature emitted by the Climatronic control unit -J255- is displayed. |
q | If the temperature reading is incorrect, check the measurement values of the temperature sensors → Vehicle diagnosis, testing and information system VAS 5051 |
q | The measurement value from the Outside temperature sensor -G17- is analysed by the Control unit in the instrument panel and transmitted over the comfort system data bus to the Climatronic control unit -J255- → Vehicle diagnosis, testing and information system VAS 5051 |
10 - | De-icing vent |
q | Windscreen |
q | Removing and fitting → Bodywork, interior fitting work; Rep. Gr.70 |
11 - | Photosensor for solar radiation -G107- andPhotosensor 2 for solar radiation -G134- |
q | Removing and fitting → Chapter → Bodywork, interior fitting work; Rep. Gr.70 |
12 - | Thermosensor - dashboard -G56- |
q | Fitted in the Climatronic control unit -J255-, this cannot be replaced separately |
13 - | Climatronic control unit -J255- |
q | Different versions (with the button OFF, with or without thermal seat regulator, with or without radio / navigation system or radio with large controls panel), allocation → Spare parts catalogue |
q | Removing and fitting → Chapter |
q | The Temperature sensor - Dashboard -G56- is incorporated into the control and indication panel Climatronic control panel -J255- |
q | Note the additional instructions for the control and indication panel → Chapter |
q | The self-diagnosis of the Climatronic control unit -J255- must be carried out as described in the guided fault finding → Vehicle diagnosis, testing and information system VAS 5051 |
q | The illumination of the push buttons and the indication areas is done using LEDs, they may not be replaced |
14 - | Left hand side centre dashboard vent |
q | Removing and fitting the dashboard air vent → Chapter and → Bodywork, interior fitting work; Rep. Gr.70 |
15 - | Right hand side centre dashboard vent |
q | Removing and fitting the dashboard air vent → Chapter and → Bodywork, interior fitting work; Rep. Gr.70 |
16 - | Air conditioning with evaporator and removable parts |
q | Air duct in the climate control and the vehicle → Chapter |
q | Climate control components in the passenger compartment → Chapter |
q | Climate control: Removing and fitting → Chapter |
17 - | De-icing vent |
q | Passenger's side window |
q | Removing and installing: → Chapter and → Bodywork, interior fitting work; Rep. Gr.70 |
18 - | Right hand side dashboard vent |
q | Removing and fitting the dashboard air vent → Chapter and → Bodywork, interior fitting work; Rep. Gr.70 |
19 - | Temperature sender for the right hand side air vent -G151- |
q | Removing and fitting → Chapter |