Leon Mk1
Note
|
1 - | Air distributor housing |
q | Do not disassemble |
q | With temperature flap and air distribution flaps |
2 - | Air flow duct, lower element |
q | Assemble the upper and lower elements → Fig. |
3 - | Clip |
q | Press upwards with a screwdriver |
4 - | Evaporator |
q | Fit the sealing element on the refrigerant pipes → Fig.. |
q | With the sealing element in the evaporator |
q | With the sealing element in the evaporator → Fig. |
5 - | Air flow duct, upper element |
q | Assemble the upper and lower elements → Fig. |
6 - | Intake duct |
q | With air recirculation and fresh air flap (speed flap) |
7 - | Clip |
q | Press upwards with a screwdriver |
8 - | Support for servomotor -V70- |
9 - | Servomotor for the central flap -V70- |
Checking: Select the function “Fault finding guide” on the Vehicle Diagnosis, Testing and Information System -VAS 5051- or later models. |
q | With potentiometer - servomotor for central flap -G112- |
q | Removing and fitting → Chapter |
q | After replacing: With the Vehicle diagnosis, testing and information system -VAS 5051-, or later models, run basic configuration → Chapter |
10 - | Ridged panel bolt |
|
|