Leon Mk1
Heating of the vehicle interior |
WARNING
|
Note
t | Before disconnecting the battery, check the radio anti-theft code. Disconnecting the battery → Electrical system; Rep. Gr.27 |
t | If the battery is re-connected, the vehicle equipment must be checked (radio, clock, electrical comfort system etc.), following the instructions in the Repair Manual and/or Owner's Manual. |
1 - | De-icing vent |
q | For the windscreen, de-icing. |
q | Removing and fitting: → Bodywork, interior fitting work; Rep. Gr.70 |
q | Crushing of intermediate piece between heater unit and air duct in instrument panel on installing instrument panel will result in irregular or inadequate air flow to windscreen. → Bodywork, interior fitting work; Rep. Gr.70 |
2 - | instrument panel nozzle, central |
q | Removal and installation → Chapter |
3 - | Instrument panel |
q | Removal and installation → Bodywork, interior fitting work; Rep. Gr.70 |
4 - | Side window nozzle |
q | Carefully remove it by levering with the removal tool -U-30800- |
5 - | Instrument panel nozzle, side |
q | Removal and installation → Chapter |
6 - | Intermediate part for the dashboard nozzle |
q | Stapled to the heating unit |
q | To remove it, it is necessary to remove the dashboard. |
7 - | Central dial |
q | Removing and installing → Chapter |
8 - | Dashboard crossbeam. |
9 - | Heating equipment |
q | Assembly overview → Chapter |
q | Removing and installing → Chapter |
10 - | Floor nozzle, right |
q | Bolted to heating unit (1.5 Nm) |
11 - | Connecting element for rear duct |
12 - | Rear duct |
13 - | End component for rear duct |
q | Fits onto rear duct and transversal strut of seats |
14 - | Air outlet grille |
q | Fit with a clip from the exterior on the transverse beam of the boot in front of the spare wheel compartment. |
q | The shutter seals should move freely and fit together without assistance |
q | The area around the air outlet grille should be free of obstructions, otherwise the vehicle interior will not be ventilated → Chapter |
15 - | Floor nozzle, left |
q | Bolted to support (1.5 Nm) |
16 - | Gasket |
q | For the heat exchanger connection |
q | In the transverse panel (mounting panel) |
17 - | Intermediate part for the anti-fog duct |
q | Fitted on the heating unit and on the module carrier |
q | The instrument panel must be dismounted in order to remove the part |
18 - | Exterior air flap and air recirculation servomotor -V113- |
q | Removing and fitting → Chapter |
19 - | Dust and pollen filter |
q | With active carbon filter |
q | Removing and fitting → Chapter |