Leon Mk1
| Cover for gearbox casing and gear change mechanism: Assembly overview |
| 1 - | Countersunk bolt |
| q | 25 Nm |
| 2 - | Flange shaft with compression spring |
| q | removing and fitting → Chapter |
| 3 - | Torx bolt |
| q | 25 Nm |
| q | M8 x 26 |
| q | For the reverse gear/shaft support |
| q | Always replace. |
| 4 - | Torx bolt |
| q | 30 Nm |
| q | M8 x 32 |
| q | For the reverse gear/shaft support |
| q | Always replace. |
| 5 - | O ring |
| q | Always replace. |
| 6 - | Bearing pin |
| 7 - | Bolt. |
| q | 25 Nm |
| 8 - | Bolt. |
| q | 25 Nm |
| 9 - | Sealing cap |
| 10 - | Multi-point socket head bolt |
| q | 25 Nm |
| q | For the reverse gear/shaft support |
| q | Always replace. |
| 11 - | Bolt. |
| q | 5 Nm |
| 12 - | Gearbox neutral position sender -G701- |
| q | For vehicles with start stop system |
| 13 - | Gearbox |
| q | Remove together with 5th gear → Chapter |
| q | Repairing → Chapter |
| 14 - | clutch housing |
| q | Repairing → Chapter |
| 15 - | Hexagonal bolt |
| q | 25 Nm + 90° |
| q | Always replace. |
| 16 - | Selector shaft |
| q | Repairing → Chapter |
| 17 - | Bolt. |
| q | 25 Nm |
