SEAT Workshop Service and Repair Manuals > Leon Mk1 > Power tramsmission | 01M 4-speed automatic gearbox | Torque converter

Slide bearing on turbine shaft: separate

Place the gearbox, in its installation position, on the gearbox oil sump.

–	Remove the torque converter.

–	Position the turbine shaft pin holes -A- horizontally.

–	Stick adhesive tape to the turbine shaft and to the holes to protect the gearbox.

–	Cut through the slide bearing using a saw blade without supporting it on the bearing joint -arrow-.

Note!

When sawing, ensure shavings do not get into the gearbox.

–	Once sawn through, carefully release the bearing, levering with a screwdriver and without damaging the turbine shaft.

–	Remove the shavings and the adhesive tape.

–	Replace the torque converter oil seal → Chapter.

SEAT Workshop Service and Repair Manuals