Leon Mk1
| Part II |
| 1 - | Cylinder head cover |
| 2 - | Cap |
| q | Replace the gasket if damaged |
| 3 - | Upper sealing washer |
| 4 - | Washer |
| 5 - | 10 Nm |
| 6 - | Cap |
| 7 - | Clip |
| 8 - | Pressure regulator valve |
| q | For crankcase breathing |
| 9 - | Gasket |
| q | Replace the gasket if damaged |
| 10 - | Cylinder head cover gasket |
| q | Replace the gasket if damaged |
| 11 - | Crankcase breather hose |
| 12 - | Cylinder head bolt |
| q | Renew |
| q | For removing and installing take the order into account |
| 13 - | O-ring |
| q | Renew |
| 14 - | 25 Nm |
| 15 - | Lower sealing cone |
| 16 - | Injection hoses |
| q | 25 Nm |
| q | Loosen/tighten with tool -U-40072- |
| q | Remove the complete set of hoses |
| q | Do not change the shape of the pipes |
| 17 - | Cylinder head |
| q | Removing and installing → Chapter |
| 18 - | Cylinder head gasket |
| q | Renew |
| q | Note the denomination |
| q | If replaced, fill the circuit with coolant |
| 19 - | 20 Nm |
| 20 - | Support |
