seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing crankshaft > < Dismantling and assembling engine

Leon Mk1

Installation
Installation
Install in reverse order but note following:
  Note!
t  When fitting the pressure assembly, pay attention to the small groove in the safety plate, which must point towards the side opposite to the engine block assembly.
t  The securing bolts of the pressure assembly must be replaced and installed with sealant. Tighten the bolts diagonally to the prescribed torque.
   
–  Centre the clutch plate, using the -U-30004- tool, and tighten the flywheel securing bolts diagonally to the prescribed torque.
  E30-0006

Removing and installing crankshaft > < Dismantling and assembling engine