Leon Mk1
Intake manifold: dismantling and assembling |
1 - | Intake manifold pressure sender -G71-* with intake air temperature sender -G42-* |
q | Resistance values for intake air temperature sender → Fig. |
2 - | O-ring |
q | Renew if damaged |
q | There is a version with a ring |
3 - | Intake manifold |
4 - | Throttle valve control unit -J338-* |
q | Checking → Chapter |
q | Components of the throttle valve control unit -J338-: Throttle valve positioner -V60-, throttle valve positioner potentiometer -G88-, throttle valve potentiometer -G69- and idling switch -F60- |
q | If the control unit is replaced, you must: Initiate basic setting → Chapter |
5 - | O-ring |
q | Renew if damaged |
6 - | 10 Nm |
7 - | Earth wire |
q | For the throttle valve control unit |
8 - | Supply hose |
q | With clip on intake manifold, lower part |
9 - | Return pipe |
q | With clip on intake manifold, lower part |
10 - | Towards solenoid valve 1 for activated charcoal filter -N80- |
q | Activated charcoal filter system → Rep. Gr.20 |
11 - | Support clip |