SEAT Workshop Service and Repair Manuals > Leon Mk1 > Power unit | 1AV Injection and Ignition System | Mixture preparation system, electronic inj.,Gas | Injection system: Repairing

Air filter: dismantling and assembling

Remove air filter → Fig.

1 -	Air filter cover

2 -	Filter cartridge

3 -	Air filter lower part

4 -

Gasket

q	Renew if damaged

5 -	Crankcase breather hose

6 -	Warm air collector

7 -	Air intake duct with regulating flap

q	Check intake air preheating → Chapter

Resistance values for coolant temperature sender -G62-

The diagram is divided into two temperature ranges:

A -	from 0…50 °C

B -	from 50…105 °C

Examples:

t	30 °C is in range A and corresponds to a resistance of 1,5…2,0 kΩ

t	80 °C is in range B and corresponds to a resistance of 275…375 Ω

Resistance values for intake air temperature sender -G42-

Examples:

t	20 °C corresponds to a resistance of 2340…2680 Ω

t	80 °C corresponds to a resistance of 290…330 Ω

Remove air filter

–	Loosen securing bolts marked with -arrows- to remove air filter.

Note!

t	When the securing bolts are loosened or tightened using a power tool, the threads in the inlet tube may be damaged. For this reason, only use a power tool in the following conditions:

t	Maximum revolutions of tool, 200/min

t	Maximum tightening torque 3 Nm

SEAT Workshop Service and Repair Manuals