Caution The fuel system is under pressure. Before opening the system, place a cloth around the connection. Then release pressure by carefully loosening the connection. |
|
To prevent injuries to persons and/or damage to the injection and ignition system, the following must be observed: |
t
| Do not touch or disconnect ignition wiring when the engine is running or being turned at starter speed. |
t
| The ignition must be switched off before connecting or disconnecting injection or ignition system wiring or tester cables. |
t
| To turn the engine at starter speed, without starting, for example: to check compression, unplug the connector from the Hall sender (ignition distributor). |
Observe the following if test and measuring instruments are required during a test drive: |
t
| Test and measuring instruments must be secured to rear seat and operated by a 2nd person from this location. |
If test and measuring instruments are operated from front passenger's seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries when the airbag is triggered. |
|
|
|