–
| Fit extractor -T10052- and align it with the holes in the hub. |
–
| Screw the fixing bolts -1- into the hub. |
–
| Pull on the hub by uniformly tightening the centre bolt -2- until the hub comes loose from the camshaft cone. |
Note! During this process, hold the extractor with a spanner e/c 30. |
–
| Remove the hub from the camshaft cone. |
–
| Remove the cylinderhead cover. |
Note! First loosen the outer bolts and then the two inner ones crosswise. |
–
| First remove caps 2 and 3. Loosen caps 1 and 4 alternately and crosswise. |
Note! Cap 4 is marked as cap 5. |
|
|
|