–
| Disconnect the electrical connector -arrow- for temperature sender 1 of the exhaust gases -G450-. |
–
| Mark the hoses so as not to confuse them when installing again pressure sensor 1 for exhaust gas -G450-. |
–
| Open the hose clamps and lubricate both hose with a non-silicone based lubricant. |
–
| Carefully and in a straight line, separate the hoses from the connecting sleeves (the sleeves break easily). |
–
| Undo the nuts -1- and remove the exhaust gas pressure sensor 1 -G450- together with the pressure pipes. |
–
| Reassembly is carried out in the reverse order; note the following: |
Note t
| Secure all hose connections with the correct hose clips (same as original equipment) → Parts catalogue. |
t
| Connect the hoses of the pressure sensor 1 of exhaust gases -G450-. |
|
|
|