seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine cooling > < Removing and installing oil supply line and oil return (turbocharger support)

Leon Mk1

Removing and installing oil pressure switchF1
Removing and installing oil pressure switch -F1-
»Carry out the following work sequence«
Removal:
–  Remove engine cover panel → Chapter.
   
–  Remove crankcase breather hose -1-, press release buttons for this.
–  Free vacuum hoses -arrows-.
–  Release hose clips -3- and pull air hose off air filter housing.
–  Unscrew bolt -2-, swing intake hose and intake unions to rear and pull off of turbocharger.
  A21-10437
–  Remove bolts -2- and -3- and detach engine lifting eye -1-.
–  Disconnect electrical connector -arrow-.
–  Remove oil pressure switch -F1-.
Installation
l  Tightening torques → Fig.
Installation is carried out in the reverse sequence; note the following:
  Note
Renew seal.
–  Install vacuum line to exhaust gas recirculation cooler.
–  Install intake pipe.
  A17-10550

Engine cooling > < Removing and installing oil supply line and oil return (turbocharger support)