SEAT Workshop Service and Repair Manuals

Removing and installing Lambda probe after catalytic converter -G130- Special tools and workshop equipment required

t  Tool set, 17 mm -T10395-

t  Lambda probe open ring spanner set -3337-

t  Torque wrench -V.A.G 1331- Carry out the following work: Removal:

–  Unlock and disconnect connectors above lambda probe after catalytic converter -G130--arrow-. Steckerfarbe schwarz -  Lambda probe -G39- Steckerfarbe braun -  Lambda probe after catalytic converter -G130- –  Remove wiring harness from guides.

–  Unscrew lambda probe after catalytic converter -G130--1- from catalytic converter -2- from below. Installation Installation is in the reverse sequence of removal. Note the following: Grease only the threads with „G 052 112 A3“ The „G 052 112 A3“ must not get into the slots on the probe body. If seal is leaking, nip open and renew.

Tightening torque:

Component	Specified torque .
Lambda probe after catalytic converter -G130-	50 Nm