Leon Mk1
| Removing and installing sealing flange and flywheel |
Note!| t | Servicing the clutch: |
| t | → 5-Speed manual gearbox 085; Rep. Gr.30 |
| 1 - | Oil seal |
| q | Renewing → Chapter |
| 2 - | 25 Nm |
| 3 - | Front sealing flange |
| q | Must be located on dowel sleeves |
| 4 - | Gasket |
| q | Renew |
| 5 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 6 - | 60 Nm + 1/4 turn (90 °) further |
| q | Renew |
| q | The quarter turn further can be done in several stages. |
| q | The turning further angle can be measured with protractor -T20030- |
| 7 - | Flywheel |
| q | To remove and install hold flywheel with counter-hold -T20075- |
| 8 - | Intermediate plate |
| q | Must be located on dowel sleeves |
| q | Do not damage/bend when assembling |
| 9 - | 10 Nm |
| 10 - | Sealing flange with oil seal |
| q | Only renew complete |
| q | Lightly oil sealing lip of oil seal |
| 11 - | Intermediate shaft |
| 12 - | O ring |
| q | Renew if damaged |
| 13 - | Sealing flange intermediate shaft |
| 14 - | Oil seal |
| q | Remove to remove sealing flange |
| q | Install with oil seal fitting tool U-30002 |
| q | Lightly oil sealing lip |
