–
| Check resistance of injectors between contacts. |
| Specification: 12 … 17 Ω∼ (at room temperature) |
Note Resistance value is valid for 20 °C approx. In the case of higher temperatures the resistance value increases. |
If the specification is obtained: |
If the specification is not obtained: |
–
| Renew the defective injector → Item. |
When removing and fitting injectors, the following should be borne in mind: |
t
| Replace the O-rings of any joint opened (to replace the front O-ring do not remove the plastic cap on the injector head under any circumstance, place the O-ring over the cap). |
t
| Before fitting, the O-rings should be lightly coated with clean engine oil. |
t
| Insert injectors vertically and in the correct position into the fuel rail and immobilise with the securing clips. |
t
| Fit fuel rail with secured injectors onto intake manifold and insert evenly. |
|
|
|