–
| Use fitting tool -T20081B/1- and press the guide bush-seal set as far as it will go. To do this, use the old securing bolt for the vibration damper. |
–
| Separate guide bush -T20081B/2-. |
–
| Fit the toothed belt sprocket. To do this, immobilise it with retaining tool -T20018A- and tighten the new securing bolt to the recommended torque → Item. |
Note! The angle of tightening can be measured with measuring tool -T20030-. |
Installing toothed belt and adjusting valve timing → Chapter. |
|
|
|