seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
1,9 l SDi engine, mechanics > < Safety valve: check and fitting position

Leon Mk1

Silencer with mountings
   
Silencer with mountings
1 - Front exhaust pipe with catalytic converter
2 - Marking
q   Three times on the contour
3 - Double clamp
q   Note the fitting position
4 - Dimension -a- = approx. 5 mm
5 - Mushroom head screw
6 - 40 Nm
7 - Front silencer → Note
8 - Suspension element
9 - 25 Nm
10 - Mounting
q   Renew if damaged
11 - Connecting piece
12 - 15 Nm
13 - 20 + 1/4 turn (90º)
14 - Rear silencer → Note
15 - Marking
q   Three times on the contour
q   Double clamp for repairs → Item
16 - Double repair clamp
q   Must be slid onto the markings → Item
17 - Separating point
q   For repair cases → Note
q   Marked by impressions on connecting pipe

1)  Front and rear silencers are installed as a single component as standard. In case of repair, front and rear silencers are supplied separated by a double clamp → Item. Cut the connecting pipe at right angle where indicated → Item with -U-40075- pliers.
   

1,9 l SDi engine, mechanics > < Safety valve: check and fitting position