Leon Mk1
Coolant pump side |
1 - | O-ring |
q | Renew when leaking and if damaged |
2 - | Coolant pump |
q | Check impellor moves freely |
q | Renew complete if leaking or damaged |
3 - | Toothed belt guard, rear |
4 - | Toothed belt guard, upper part |
5 - | Bolt |
q | 90 Nm + 1/4 turn (90°) further |
q | Renew |
q | Insert oiled |
q | Turning further can be completed in many stages |
q | Turning further angle can be measured using protractor -T20030-. |
6 - | Belt pulley |
q | When installing not fixtures |
q | Use counter-hold -T20018A- when loosening and tightening |
q | Removing and installing ribbed belt → Chapter |
7 - | Toothed belt guard, lower part |
8 - | Bolt |
q | 10 Nm |
9 - | Bolt |
q | 20 Nm |
10 - | Nut |
q | 20 Nm |
11 - | Tensioning roller |
q | Tensioning toothed belt → Chapter |
12 - | Toothed belt |
q | Check for wear |
q | Do not kink |
q | Tensioning toothed belt → Chapter |