Leon Mk1
Thermostat side |
1 - | Bracket |
q | For switch |
2 - | Self-cutting thread screw |
3 - | From bottom of radiator |
q | Connection diagram for coolant hoses → Chapter |
q | → Item |
4 - | Connection union |
5 - | O-ring |
q | Renew |
6 - | Thermostat |
q | Checking function: Heat up thermostat in water. The pin of the thermo element must move out. |
q | Checking temperature: Commences to open (approx. 84 °C) and ends (approx. 98 °C) cannot otherwise be checked. |
7 - | To expansion tank |
q | Connection diagram for coolant hoses → Chapter |
8 - | To heat exchanger |
q | Connection diagram for coolant hoses → Chapter |
9 - | From expansion tank |
q | → Item |
q | Connection diagram for coolant hoses → Chapter |
10 - | Retaining clip |
q | Check seated securely |
11 - | From heat exchanger |
q | Connection diagram for coolant hoses → Chapter |
12 - | Coolant pump housing on cylinder block |
13 - | Seal |
q | Renew |
14 - | Coolant pipe |
15 - | Thermostat housing |
16 - | Bolt |
q | 10 Nm |
17 - | Coolant temperature sender -G62- |
q | Green |
q | For engine control unit |
q | With coolant temperature gauge sender -G2- |
q | Before removing, release pressure in coolant system if necessary |
18 - | Sealing plug |
q | Before removing, release pressure in coolant system if necessary |
19 - | To top of radiator |
q | → Item |
q | Connection diagram for coolant hoses → Chapter |
20 - | Connector |
q | 4-pin |
q | Contacts 1 and 3 for engine control unit |
q | Contacts 2 and 4 for temperature gauge in dash panel |