Leon Mk1
Exhaust manifold, front exhaust pipe with catalytic converter, Lambda probe |
1 - | Warm air collector plate |
2 - | Bolt |
q | 10 Nm |
3 - | Exhaust manifold |
q | Only engines conforming to EU IV with an integrated starter catalytic converter |
4 - | Gasket |
q | Renew |
5 - | Nut |
q | 25 Nm |
6 - | To front silencer |
7 - | Front exhaust pipe with catalytic converter |
8 - | Bolt |
q | 25 Nm |
9 - | Tunnel bridge |
q | With retaining rings for front exhaust pipe with catalytic converter |
q | Renew if damaged |
10 - | Front exhaust pipe with catalytic converter |
11 - | Lambda probe before catalytic converter |
q | Grease only the threads with “G 052 112 A3”; “G 052 112 A3” must not get into the slots on the probe body |
q | Remove and install with ring spanner -U-40080- |
12 - | Connector |
q | For Lambda probe before catalytic converter -G39- and Lambda probe heater -Z19- |
q | Black, 4-pin |
q | Contacts are gold plated |
13 - | Securing nut |
q | 40 Nm |
14 - | Gasket |
q | Renew |
15 - | Retaining bracket |
q | For electrical cable for Lambda probe before catalytic converter |