Leon Mk1
Crankshaft - exploded view |
1 - | Bearing cap |
q | For cylinder block (with oil groove) |
q | Mark used bearing shells for re-installation but not on bearing surface |
2 - | Gears |
q | For oil pump drive |
q | Not available as separate replacement part |
3 - | Bearing cap |
q | For bearing cap (without oil groove) |
q | Mark used bearing shells for re-installation but not on bearing surface |
q | Renew bearing shells worn down to base layer. |
4 - | Thrust washers |
q | For bearing 3. |
q | Various versions for cylinder block and bearing cap. |
q | Note location |
5 - | Bolts |
q | Replace |
q | 65 Nm + turn 90° further |
6 - | Bearing cap |
q | Bearing cap 1: Pulley side: |
q | Bearing cap 3 with recesses for thrust washers |
q | Fitting position: Retaining lugs on bearing shells in cylinder block and bearing cap must be on the same side |
7 - | Crankshaft |
q | New axial play: 0.07 ... 0.17 mm Wear limit: 0.37 mm |
q | Checking radial clearance with Plastigage: new: 0.03 ... 0.08 mm, Wear limit: 0.17 mm |
q | Do not rotate crankshaft when checking radial clearance. |
q | Crankshaft dimensions → Chapter. |