seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine cylinder head, valve gear > < Pistons and conrods: dismantling and assembling

Leon Mk1

Poly-V belt with tensioning element and air conditioner compressor: Removing and installing
Poly-V belt with tensioning element and air conditioner compressor: Removing and installing
t  Removing → Anchor
t  Installing → Anchor
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Hose clamp -T10060A-, see equivalent → Anchor
Removing
–  Remove the soundproofing or the underbody protection → Bodywork, exterior assembly work; Rep. gr.50.
  Note
Before removing the ribbed belt, mark its running direction with chalk or with a felt tipped pen. Running a used belt in the opposite direction could destroy it.
  W00-10235
–  Slacken ribbed belt, turn tensioning element in -direction of arrow-.
  N15-10398
–  Place the holes -arrows- above each other and lock the clamping element using the retention tool -T10060A-.
–  Take off poly V-belt.
Installing
Installation is carried out in reverse order, noting the following:
  Note
t  Before fitting the Poly-V belt ensure that all sub-assemblies (alternator and air conditioning compressor) are tight.
t  When fitting the ribbed belt, ensure that it is fitted with the correct direction of rotation and that it is correctly seated on the pulleys.
t  For those vehicles not fitted with air conditioning, fit the Poly-V belt lastly on the alternator.
t  For those vehicles fitted with air conditioning, fit the ribbed belt lastly on the compressor for the air conditioning.
  N13-10297
–  Place the Poly-V belt onto the crankshaft pulley:
1 - Crankshaft
2 - Tensioner
3 - Alternator
4 - Air conditioning compressor
  A13-10597
–  Support the clamping element using an annular wrench and remove the retention tool -T10060A-.
–  Slacken tensioner.
–  Check Poly-V belt is correctly positioned.
–  Start the engine and check that the Poly V-belt rotates correctly.
  N15-10398

Engine cylinder head, valve gear > < Pistons and conrods: dismantling and assembling