Leon Mk1
Assembly overview - crankcase |
1 - | Cylinder block |
q | Removing and installing sealing flanges and flywheel/drive plate → Chapter |
q | Removing and installing crankshaft → Chapter |
q | Dismantling and assembling pistons and conrods → Chapter |
2 - | Gasket |
q | Renew. |
3 - | Oil filter bracket |
q | Ensure clearance to adjacent components. |
q | Dismantling and assembling: |
q | Engine codes ANU, AUY, BVK → Chapter |
q | Engine codes ASZ, BTB → Chapter |
4 - | 15 Nm + 1/4 turn (90°) further |
q | Renew. |
q | First fit upper left and lower right bolts and then tighten all four bolts diagonally. |
5 - | 15 Nm |
6 - | Engine speed sender -G28- |
7 - | Connection |
q | For thermostat. |
8 - | 15 Nm |
9 - | O-ring |
q | Renew. |
10 - | Thermostat |
q | Removing and installing → Chapter. |
q | Note installation position → Chapter. |
q | Check: Heat thermostat in water |
q | Opening begins at approx. 87 °C |
q | Ends at approx. 102° C. |
q | Opening lift at least 7 mm. |
11 - | 45 Nm |
q | Observe tightening sequence → Fig.. |
12 - | Ancillary bracket |
q | For alternator, power assisted steering vane pump and air conditioner compressor |
13 - | Sump |
q | Clean sealing surface before fitting. |
q | Install with silicone sealant -D 176 404 A2- |
q | Removing and installing → Chapter. |
14 - | 15 m |