SEAT Workshop Service and Repair Manuals > Leon Mk1 > Power unit | 4-cylinder diesel engine (2.0 l 4V, TDI Common-Rail) | Engine assy,cylinder block,crankcase | Removing and positioning the engine

Detaching engine from gearbox

Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	counterhold -T20186-, see equivalent → Anchor

t	Workshop crane -VAS 6100-, see equivalent → Anchor

Requirement

l	Engine/gearbox assembly removed and fixed on engine bracket -T20205-.

Operation process

–	Unscrew bolt -1- with gearbox fitted.

–	Pull the cover plate -2- off upwards.

Note

This is shown in the figure with the gearbox removed.

–	Remove bolts -1 ... 8- from engine/gearbox flange.

–	Take out starter motor.

Note

The gearbox is shown in illustration with engine removed.

–	Place the support tool -T20186- on the gearbox, as shown in the illustration.

–	Carefully separate the gearbox from the engine, using the workshop crane -VAS 6100-.

SEAT Workshop Service and Repair Manuals