Leon Mk1
|
1 - | 10 Nm + 90° (1/4 turn) |
q | 4x |
q | replace |
2 - | Pulley / damper |
q | Fitting is only possible in one position, the holes are arranged asymmetrically |
3 - | 25 Nm |
q | 3x |
4 - | Tensioning device for Poly-V belt: |
q | Rotate using a 16 mm spanner for releasing the tension on the Poly-V belt → Chapter |
5 - | Retainer |
q | For Alternator |
6 - | 45 Nm |
q | 6x |
q | Follow the correct tightening order → Fig. |
7 - | Retainer |
q | For the lower part of the supercharger air tube |
8 - | 10 Nm |
q | 2x |
9 - | Alternator |
10 - | 25 Nm |
11 - | Poly-V belt |
q | Mark direction of rotation before removing |
q | check wear |
q | Do not bend the belt |
q | removing and fitting → Chapter |