SEAT Workshop Service and Repair Manuals > Leon Mk1 > Power unit | 4-cylinder engine (2.0l 4V, TDI Common Rail) | Enginecrankshaft group, pistons | Crankshaft | Extracting and driving in needle bearing for crankshaft

Extracting and driving in needle bearing for crankshaft

Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Punch -VW 207 C- or centring punch -3176-, see equivalent → Anchor

t	-1-Internal extractor -Kukko 21/1-, see equivalent → Anchor

t	-4-Support bracket -Kukko 22/1-, see equivalent → Anchor

Note

A needle bearing must be fitted in the crankshaft on vehicles with manual gearbox. Fit it if necessary.

Remove

–	Remove needle bearing with aid of inner puller -Kukko 21/1- and counterbearing -Kukko 22/1-.

Driving in

–	Insert in needle bearing with drift -VW 207 C- or centring mandrel -3176-.

l	The lettering on the needle bearing must be visible when installed.

SEAT Workshop Service and Repair Manuals