Leon Mk1
Cooling system components, bodywork side - Assembly overview |
1 - | O-ring |
q | Renew |
2 - | Upper coolant hose |
q | Secured to radiator with retaining clips |
q | Check firm seating |
q | Coolant hose schematic diagram → Chapter |
3 - | Coolant hose |
q | To preheat the crankshaft sump breather (location: In the intake manifold) |
Note
To remove the crankshaft sump breather preheating device, first dismount the intake manifold. |
4 - | Radiator |
q | Removing and installing → Chapter |
q | After replacing, renew coolant completely |
5 - | Radiator fan |
q | This is mounted on the radiator with three bolts |
6 - | Connector |
7 - | Radiator fan thermoswitch -F18-, 35 Nm |
q | For electric fan |
Switching temperatures |
q | 1ª speed engaged 92 - 97 °C, disengaged 84 - 91 °C |
q | 2ª speed engaged 99 -105 °C, disengaged 91 -98 °C |
8 - | Goes to coolant pipe |
q | Coolant hose schematic diagram → Chapter |
9 - | Expansion tank |
q | Check the cooling system for leaks using the cooling system tester -V.A.G 1274- and the cooling system tester adaptor -V.A.G 1274/8- |
10 - | 10 Nm |
11 - | Plug |
q | Check using the cooling system tester -V.A.G 1274- and the cooling system tester adaptor -V.A.G 1274/9- |
q | Test pressure: 1.4 -1.6 bar. |
12 - | Lower coolant hose |
q | Secured to radiator with retaining clips |
q | Check firm seating |
q | Coolant hose schematic diagram → Chapter |
13 - | Support |
q | For radiator |
q | Note the fitting position |
q | Note various versions |