Leon Mk1
Catalytic converter and attaching parts - Assembly overview |
1 - | Heat shield |
2 - | Gasket |
q | replace |
3 - | Gasket |
q | replace |
4 - | Catalytic converter with exhaust pipe |
5 - | 25 Nm |
q | replace |
6 - | 25 Nm |
7 - | To intermediate silencer |
8 - | 25 Nm |
9 - | Mounting |
q | Renew if damaged. |
10 - | Exhaust pipe |
q | With decoupling element |
q | Do not bend flexible joint more than 10° - otherwise it can be damaged |
q | removing and installing → Chapter |
11 - | 23 Nm |
q | replace |
12 - | Gasket |
q | replace |
13 - | Lambda probe after catalytic converter -G130-, 50 Nm |
q | Grease only the threads with „G 052 112 A3“; „G 052 112 A3“ must not get into the slots on the probe body. |
q | If seal is leaking, nip open and renew. |
14 - | 10 Nm |
15 - | Bracket |
q | For electrical cables. |
16 - | Lambda probe -G39-, 50 Nm |
q | Grease only the threads with „G 052 112 A3“; „G 052 112 A3“ must not get into the slots on the probe body. |
q | Remove and install with Lambda probe open ring spanner set -3337-. |
17 - | 25 Nm |
Observe tightening sequence: items -A- to -I- → Chapter . |
18 - | Exhaust turbocharger |
Caution
|
q | The turbocharger and the exhaust manifold can only be renewed together. |
19 - | 10 Nm |