Leon Mk1
Compressor - exploded view |
1 - | Housing with soundproofing |
q | For noise insulation |
2 - | Noise insulation |
q | For intake air |
3 - | Suction line |
q | Immobilise with spring clips |
4 - | 7 Nm |
q | Self-tapping bolt. |
q | Securing bolt must only be tightened with a nut runner if nut runner speed is max. 500 rpm and a max. tightening torque of 7 Nm is set. |
5 - | 7 Nm |
6 - | 7 Nm |
q | Self-tapping bolt. |
q | Securing bolt must only be tightened with a nut runner if nut runner speed is max. 500 rpm and a max. tightening torque of 7 Nm is set. |
7 - | O ring |
q | replace |
8 - | Pressure pipe |
9 - | Noise insulation |
10 - | Housing |
q | For noise insulation |
11 - | Noise insulation |
q | For charge air. |
q | With seal. |
q | Renew seal between supercharger and noise insulation. |
12 - | Pulley |
q | For supercharger. |
13 - | 8 Nm |
14 - | Coolant pump with magnetic clutch for supercharger -N421- |
15 - | Poly-V belt |
q | For supercharger. |
Caution
|
16 - | 23 Nm |
17 - | Tensioning element |
q | For supercharger poly V-belt. |
q | Relieve tension using 16 mm open-end spanner -T10241-. |
q | Lock with locking pin -T10060 A-. |
18 - | 40 Nm + 1/4 turn (90°) further |
q | To loosen and tighten securing bolt, counterhold supercharger shaft with spanner. |
q | replace |
19 - | Compressor |
q | removing and installing → Chapter |
20 - | 25 Nm |