Note t
| The cooling system is under pressure when the engine is warm. Therefore, this pressure must de reduced before repairing. |
t
| Hose connections are secured with spring-type clips. In cases of repair, only use spring-type clips. |
t
| To fit spring type clips use pliers -SAT 1105-. |
t
| When fitting, route coolant hoses without tension and not touching other components (note marking on coolant connection and hose). |
Perform cooling system leakage check with the cooling tester -SAT 1274- and the adapter -VAG 1274/8- and adapter -VAG 1274/9- → Chapter |
Bodywork side cooling system components → Chapter. |
Engine cooling system components, engine side → Chapter. |
Diagram of coolant hose connections → Chapter |
Instructions on coolant mixture → Anchor |
|
|
|