Removing and Fitting Cooling System on Leon Mk1
| Cooling system, bodywork side: removing and fitting |
| 1 - | Spring type clips |
| 2 - | Upper coolant hose |
| q | Note the fitting position |
| q | Diagram of coolant hose connections → Chapter |
| 3 - | Coolant hose |
| 4 - | 10 Nm |
| 5 - | Plug |
| q | Check with cooling system tester -SAT 1274- and adaptor -VAG 1274/9- |
| q | Opening pressure: 1.4 - 1.6 bar |
| 6 - | Expansion tank |
| q | Perform cooling system leakage check with cooling system tester -SAT 1274- and the adaptor -VAG 1274/8- |
| 7 - | Towards thermostat cover |
| q | Diagram of coolant hose connections → Chapter |
| 8 - | Mounting |
| q | Bolt: 10 Nm |
| q | For radiator |
| q | Note the fitting position |
| 9 - | Air duct |
| 10 - | 10 Nm |
| 11 - | Lower coolant hose |
| q | Check firm seating |
| q | Diagram of coolant hose connections → Chapter |
| 12 - | Spring type clip |
| 13 - | Rubber receiver |
| 14 - | Electric ventilator |
| 15 - | Connector |
| 16 - | Radiator fan thermoswitch -F18-, 35 Nm |
| q | For the radiator fan |
| Switching temperatures |
| 1a speed |
| q | Connect: 92 … 97 ? |
| q | Disconnect: 84 … 91 °C |
| 2a speed |
| q | Connect: 99 … 105 ? |
| q | Disconnect: 91 … 98 °C |
| 17 - | Radiator |
| q | Removing and installing → Chapter |
| q | After replacing, renew coolant completely |
