seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Equivalence table according to relevance > < Exhaust system on vehicles with four-wheel drive

Leon Mk1

Glow plugs: verification
Glow plugs: verification
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Auxiliary cable kit -VAG 1594C-, see equivalent → Anchor
  W00-10008
t  Articulated wrench e/c 10 -3220-, see equivalent → Anchor
t  Torque wrenches -V.A.G 1331-
t  Pressure tester -VAG 1527B-
Check conditions:
l  Battery voltage at least 11.5 V
l  Ignition off.
Checking sequence
–  Extract the connections of the glow plugs.
  W00-0329
–  Connect the cable from the voltage tester -VAG 1527B- to the (+) positive battery terminal using the pincers from the auxiliary measurement set -VAG 1594C- .
–  Apply the testing point of the voltage tester -VAG 1527B- to each glow plug, one by one.
–  Diode lights up: Glow plug okay
–  Diode does not light up: Replace glow plug
–  Remove and install the glow plugs using articulated wrench, -3220-, tightening torque: 15 Nm.
  N28-0185

Equivalence table according to relevance > < Exhaust system on vehicles with four-wheel drive