seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Radiator: Removing and installing > < Coolant: draining and filling|Drain
Fill
Fill
  Note!
t  Use only TL VW 774 D standard antifreeze G12. It is distinguishable by the red colour.
t  Never mix G12 with other antifreezes.
t  If the liquid in the expansion tank is brown, that means the G12 has been mixed with other antifreeze, in which case all the coolant must be changed.
t  G12 and the antifreeze additives with the indication “TL VW 774 D standard” prevent damage from corrosion, freezing or scale, also increasing the coolant boiling temperature. Therefore, the cooling system should always have the prescribed antifreeze and corrosion protection fluid.
t  Because of its high boiling point, the coolant improves engine reliability under heavy loads, particularly in countries with tropical climates.
t  Protection against frost should be assured to approximately -25°C (in countries with arctic climates to approximately -35°C).
t  The coolant concentration must not be reduced by adding water, even in warmer seasons and warmer countries. The antifreeze ratio must be at least 40%.
t  If, for climatic reasons, a greater frost protection is required, the amount of G12 can be increased, but only up to 60% (frost protection up to -40°C), as otherwise frost protection and cooling effectiveness is reduced again.
t  Do not use the used coolant if any of the following has been replaced: the radiator, the heat changer, the cylinder head or the cylinder head gasket.
Recommended mixture proportions:
   
Protection against frost up toAntifreeze proportionG12 → NoteWater → Note
-25°C
-35°C
40%
50%
2.25 l
2.8 l
3.35 l
2.8 l

1)  The quantity of coolant may vary according to the equipment on each vehicle.
   
–  Fill with coolant until the max. mark of the expansion tank.
–  Close the expansion tank.
–  Run the engine until the fan starts up.
–  Measure the coolant level and, if necessary, top up. With the engine hot the coolant level should be at the max. mark, and with the en-gine cold, between the min. and max. marks.
–  Install the soundproofing sump: → Rep. Gr.50.
  V19-0579

Radiator: Removing and installing > < Coolant: draining and filling|Drain