t
| Engine/gearbox support crossmember -U-30025B- |
t
| Engine/gearbox lift -SAT 1001A- |
–
| Detach the front exhaust pipe from the exhaust manifold. |
–
| Fit crossmember -U-30025- and remove the fixing bolts from the rear engine unit supports (disconnect the connection of lambda probe 2). |
–
| Remove the tunnel bridge and the double clamp that holds the catalyst to the middle presilencer. |
–
| Lower the engine unit support partially with hydraulic jack -SAT 1001A- (if necessary, remove the fixing bolt from the articulated steering shaft). |
–
| Remove the antithermal plate and remove the front exhaust pipe section with catalyst. |
Fit in the reverse order of removal. |
|
|
|