Leon Mk1
|
1 - | Warm air collector plate |
2 - | 10 Nm |
3 - | Lambda probe -G39-, 50 Nm |
q | Only grease thread with “G 052 112 A3”. The “G 052 112 A3” must not reach the probe body grooves |
q | Remove and install with wrench -U-40080- |
q | If sealing ring is leaking, nip open and replace |
4 - | Exhaust manifold with precatalyst |
5 - | Gasket |
q | Renew |
6 - | 25 Nm |
q | Renew |
7 - | Connector |
q | 4 pins |
8 - | Connector |
q | 4 pins |
9 - | Lambda after catalytic converter -G130- 55 Nm |
q | Only grease thread with “G 052 112 A3”. The “G 052 112 A3” must not reach the probe body grooves |
q | Remove and install with wrench -U-40080- |
q | The connector is found under the right hand side floor lining. |
10 - | Double clamp, 25 Nm |
q | Align exhaust system when it is cold so it is free of stress before tightening clamp |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
11 - | Front tube bridge |
12 - | 23 Nm |
13 - | Forward section of the exhaust tube with catalytic converter |
q | The vibration damper must not be bent more than 10°, otherwise it will be damaged |
14 - | Securing ring |
q | Replace if damaged |
15 - | 20 Nm |
16 - | 40 Nm |
q | Renew |
17 - | Support |
18 - | Cable guide |
|