Measuring radial clearance of camshafts |
Special tools and workshop equipment required |
–
| Remove roller rocker finger. |
–
| Remove bearing cap and clean crankshaft journal. |
–
| Place a Plastigage corresponding to the width of the bearing on the journal or into the bearing shells. |
l
| The Plastigage must lie in the middle of the bearing. |
–
| Fit retainer frame and tighten to 10 Nm → Fig. without twisting crankshafts. |
–
| Remove the bearing cap module. |
–
| Compare width of Plastigage with the measurement scale. |
l
| Radial clearance: 0.035 ... 0.085 mm. |
|
|
|