SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing ancillary bracket >
< Poly-V belt without air conditioner compressor: Removing and installing
Leon Mk1
Power unit
4 cylinder Diesel engine (2.0 litre engine, Common Rail, Generation II)
Enginecrankshaft group, pistons
Engine: assembly and dismantling
Removing and installing vibration damper
Removing and installing vibration damper
Removing and installing vibration damper
t
Vibration damper: Removing
→ Anchor
t
Vibration damper: Fitting
→ Anchor
t
Tightening torques
→ Anchor
Removing
–
Remove poly V-belt
→ Anchor
.
–
Fit the centre noise insulation
-fasteners 1 ... 3-
.
–
Fit the right noise insulation
-fastening parts 1 ... 3-
.
–
Remove the vibration damper hood.
–
Unscrew the vibration damper. For this purpose, counterhold using a ring spanner.
Note
To loosen and to tighten the vibration damper, hold it on the centre bolt using a ring spanner.
Installing
Installation is carried out in reverse order, noting the following:
–
Use new bolts.
–
When installing the vibration damper, use only genuine bolts (same as original equipment):
→ Parts catalogue
.
l
Fitting can only be completed in one position only: The hole
-arrow-
in the vibration damper must fit over the projection on the pulley.
Tightening torques
Component
Nm
Vibration damper to the crankshaft notched pulley
10 + 90°
1)
2)
l
1)
Renew bolts
l
2)
90° is equivalent to a quarter turn
Power unit
4 cylinder Diesel engine (2.0 litre engine, Common Rail, Generation II)
Enginecrankshaft group, pistons
Engine: assembly and dismantling
Removing and installing vibration damper
Removing and installing ancillary bracket >
< Poly-V belt without air conditioner compressor: Removing and installing