Leon Mk1
Belt routing: Assembly overview |
1 - | Notched belt |
q | Mark direction of rotation before removing |
q | Check for wear. |
q | Do not kink. |
q | Removing, installing and tensioning → Chapter |
2 - | 120 Nm + turn 90° further |
q | Renewing |
q | Use counterhold -3415- to loosen and display |
q | Do not additionally oil or grease the threads and shoulder |
q | The retightening can be done in steps |
3 - | Crankshaft cogwheel |
4 - | 20 Nm |
5 - | Idler roller |
6 - | 20 Nm + turn 45° further |
7 - | Tensioning roller |
q | For removing and installing, remove the engine bracket → Chapter |
8 - | 20 Nm + turn 45° further |
9 - | Cogwheel for timing belt |
10 - | 20 Nm |
11 - | 100 Nm |
12 - | Hub |
q | Use counterhold -T10051- to loosen and display |
q | For removal use the extraction tool -T10052- |
q | Removing and installing → Chapter |
13 - | Rear notched belt guard |
14 - | 20 Nm |
15 - | 10 Nm |
q | Renewing |
16 - | Idler roller |
17 - | 50 Nm + turn 90° further |
q | Renewing |
18 - | Hub |
q | Use counterhold -T10051- to loosen and display |
q | To remove use the extractor -T40064- |
q | Removing and installing → Chapter |
19 - | 95 Nm |
20 - | Gear wheel of the high-pressure pump |
21 - | 20 Nm + turn 90° further |
q | Renewing |
22 - | Coolant pump |
q | Removing and installing → Chapter |
23 - | 15 Nm |
24 - | Upper protection element for the notched belt |
25 - | Notched belt guard - lower part |
26 - | Toothed belt guard centre part |
27 - | 10 Nm |
q | Renewing |
28 - | 10 Nm + turn 90° further |
q | Renewing |
29 - | Belt pulley and vibration damper |
q | Can only be installed in one position (as the holes are off-set) |
30 - | 5 Nm |
31 - | Protective plate |
32 - | 40 Nm + turn 180° further |
q | Renewing |
q | Observe tightening sequence → Chapter. |
33 - | Engine mounting |
q | Removing and installing → Chapter |