–
| Unplug the electrical connector -2-. |
–
| Undo the screws -3- and remove the bracket of the pressure differential sender -G505--arrow-. |
Installation is carried out in reverse sequence; note the following: |
Note t
| Before installing, blow out control lines of pressure differential sender -G505- to particulate filter with compressed air towards particulate filter (blocked or iced up due to condensation). |
t
| The hose line must have a fixed connection so that no leakage can occur. |
t
| Observe the reference markings for installing the hose line. |
t
| If pressure line has been released from particulate filter, re-tighten the pressure line → Chapter. |
Adaptation must be performed after renewing pressure differential sender -G505- and/or particulate filter. (The procedure is also described under Guided Functions.) |
Select the correct vehicle in Guided Fault Finding. |
–
| Press „Function/component selection“. |
–
| „Select engine assembly (Repair group 01, 10-39)“ |
–
| Select the corresponding engine code |
–
| „01 - Self-diagnosis-compatible systems“ |
–
| Select „01 - Direct diesel injection and diesel pre-heating system EDC“ |
–
| Select „01 - Functions“ |
–
| Select „01 - Reset the learn values of the pressure differential sender DPF“ |
|
|
|