–
| Connect oil pressure tester -V.A.G 1342- with adapter -V.A.G 1342/14- to bore for oil pressure switch. |
–
| Fit oil pressure switch -2- in the oil pressure tester -V.A.G 1342-. |
–
| Connect brown wire of oil pressure tester to earth („–“). |
Checking oil pressure switch |
–
| Attach the voltage meter -V.A.G 1527 B--Item 1- into the oil pressure switch and connect the plus pole of the battery („+“); Use the auxiliary cable of the auxiliary measurement set -V.A.G 1594 C- for this purpose. |
l
| LED should not light up. |
–
| Renew oil pressure switch. |
Note The switching point of the oil pressure switch can be reached when the engine is cranked on the starter motor, so watch the tester and the test lamp while starting the engine. |
l
| LED should light up at 1.2…1.6 bar. |
If the LED does not light up: |
–
| Renew oil pressure switch. |
l
| Minimum oil pressure at 2,000 rpm at least min. 1.3 bar |
l
| Minimum oil pressure at 3500 rpm: min. 3.5 - 4.5 bar. |
If results do not match specifications: pressure relief valve or oil pump defective. |
Assembly is carried out in the reverse order to removal; note the following: |
Note Renew seal when installing oil pressure switch. |
|
|
|