SEAT Workshop Service and Repair Manuals

Renewing inlet camshaft oil seal Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Extractor -2085-, see equivalent → Anchor

t  Guide sleeve -T10071-, see equivalent → Anchor t  Bolt M8 x 60: Operation process

–  Release quick fasteners -arrows- and remove engine cover panel. –  Remove upper notched belt guard.

–  Separate the plug connections -arrow- of the Hall sensors -G40-. –  Remove Hall sender housing and also washer and rotor for Hall sender.

–  To guide oil seal extractor, screw bolt -2085/1- into camshaft as far as it will go until finger-tight. –  Unscrew inner part of oil seal extractor -2085- two turns (approx. 3 mm) from the outer part and lock in position with the knurled screw.

–  Oil the threaded head of theextractor -2085-, place and push forcefully as far as it will go into the gasket. –  Loosen the knurled head screw and turn the inner part against the cam shaft till the sealant ring (gasket) has engaged.

–  Place the guide sleeve -T10071/5- onto the camshaft journal.   Note Do not oil seal sealing lip. –  Slide oil seal over guide sleeve onto camshaft journal. –  Take off guide sleeve.

–  Press oil seal in as far as the stop using press sleeve -T10071/3- and bolt M8x60. –  Install Hall sender → Item. –  Install top section of toothed belt cover making sure it engages securely on centre section of toothed belt cover in the process. Tightening torques

Component	Nm
Rotor for Hall sender to camshaft	25
Hall sender housing to cylinder head	10